Cookies on our website
Our website uses cookies to ensure that we give you the best user experience.
By continuing to browse our website, you are agreeing to the use of cookies.

 
More Information
Tensile Test

Tensile Test

For tensile tests on pipes specimens are taken from the pipe wall.  The thickness of the specimen generally corresponds to the pipe wall thickness and the specimen is curved along its longitudinal axis in accordance with the pipe diameter. 

A testing standard frequently used for thermoplastic pipes is ISO 6259. There are, however, depending on type of pipe, material and country of use, many additional national and international standards. 

Typical Products for this Application:

 

Zwicki modellen är materialprovningsmaskiner i laster upp till 5 kN

Fyra lastområden erbjuds - 500 N, (112lbf), 1 kN (224 lbf), 2.5 kN (562 lbf) and 5 kN (1125 lbf) alla med tre olika slaglängder.

 

 

Specimen preparation for plastics

The ZCP 020 manual cutting press employs the bent-lever principle. Attractive detail solutions allow accurate, convenient, energy-saving operation. The bent-lever length was selected to achieve up to 30 % higher cutting force in the starting range than with conventional presses. This cutting-press features particularly operator-friendly design and can be placed on any workbench or laboratory table or mounted at optimum height on a suitably sturdy wall. In addition, particular emphasis has been placed on simple, quick, and exact height adjustment of the compression die to accommodate varying heights of different cutting blades.
 

Kontakt

ZR Sverige AB
Tel.  +46 (0)31 933 480
E-Mail  info@zwick.se
Fråga nu

Kontaktbegäran
Hälsning*
Land*
* Obligatoriska fält