Cookies on our website
Our website uses cookies to ensure that we give you the best user experience.
By continuing to browse our website, you are agreeing to the use of cookies.

 
More Information
  • Tensile Characteristics and Tear Growth Strength
  • Tensile Characteristics and Tear Growth Strength

Tensile Characteristics and Tear Growth Strength

Specimens for these tests are usually taken from finished parts or a from a sheet; cutting presses with standardized blades are available from Zwick. It is important that the blades are provided with an ejector to avoid the risk of operator injury during specimen removal.
 
Various pneumatic or mechanical specimen grips are available.
 
For measurement of the strain at break, Zwick supplies mechanical and optical long-stroke extensometers. 
 

Typical Products for this Application:

 

Zwicki modellen är materialprovningsmaskiner i laster upp till 5 kN

Fyra lastområden erbjuds - 500 N, (112lbf), 1 kN (224 lbf), 2.5 kN (562 lbf) and 5 kN (1125 lbf) alla med tre olika slaglängder.

 

 

Specimen preparation for plastics

The ZCP 020 manual cutting press employs the bent-lever principle. Attractive detail solutions allow accurate, convenient, energy-saving operation. The bent-lever length was selected to achieve up to 30 % higher cutting force in the starting range than with conventional presses. This cutting-press features particularly operator-friendly design and can be placed on any workbench or laboratory table or mounted at optimum height on a suitably sturdy wall. In addition, particular emphasis has been placed on simple, quick, and exact height adjustment of the compression die to accommodate varying heights of different cutting blades.
 

Kontakt

ZR Sverige AB
Tel.  +46 (0)31 933 480
E-Mail  info@zwick.se
Fråga nu

Kontaktbegäran
Hälsning*
Land*
* Obligatoriska fält