Cookies on our website
Our website uses cookies to ensure that we give you the best user experience.
By continuing to browse our website, you are agreeing to the use of cookies.

 
More Information

HIT230F drop weight tester

The HIT230F drop weight tester was developed in close collaboration with our customers, allowing all the relevant requirements of research and development and quality assurance to be met. It is available in two versions. It is not possible to combine the two tests.


HIT230F drop weight tester for plastics

HIT230F drop weight tester for plastics

The HIT230F drop weight tester is ideally equipped for performing multiaxial impact tests on plastics. The range of application includes material characterization of standard specimens in accordance with established research and development and quality assurance standards.

Advantages of the drop weight tester for plastics:

  • tests possible over a wide temperature range without installing an expensive temperature chamber in the test frame
  • The innovative design of the entire force measurement chain leads to a low noise measurement data. This allows a reliable determination of the materials characteristics to be achieved from the force-deformation curve
  • ergonomic specimen clamping plus safety device for high specimen throughput
  • high measured-value acquisition-rate (4 MHz) combined with high (16-bit) resolution.

HIT230F drop weight tester - pre-damaging fiber composites for CAI tests

HIT230F drop weight tester - pre-damaging fiber composites for CAI tests

The instrumented HIT230F drop weight tester is ideally equipped for pre-damaging composite plates for the CAI (compression after impact) test used widely in the aerospace industry.

Advantages of the drop weight tester for CAI tests:

  • innovative force-measurement chain design delivers very low-noise measured values targeted introduction of pre-damage can be monitored in detail
  • high measured-value acquisition-rate (4 MHz) combined with high (16-bit) resolution.
  • precise, stepless damage-energy adjustment achieved by varying drop weight and drop height
  • accurate determination of actual impact speed shortly before point of impact
  • mechanical device arrests drop weight after initial impact.

Videos

 

Pre-damage of plates made of composites - Vorschädigung von Faserverbundwerkstoffen

Drop Weight Tester HIT230F - Pre-damage of plates made of composites for CAI tests - Fallwerk HIT230F - ...
Video 00:01:37
98_Fallwerk_CAI.wmv (13.2 M)

Kontaktbegäran
Hälsning*
Land*
* Obligatoriska fält